A light came on.
Key off. Touch the one you saw and it lights the way it does in your car. Then you will know whether to pull over.
22 lights.
No light matches that. Try the colour and the part, like red battery.
Symbols differ a little from make to make. Your owner’s manual wins.
Touch a light.
Its reading appears here. No light is on. The car is off.
- Red. Stop when it is safe.
- Amber. Get it looked at soon.
- Green and blue. A system is on.
Every light, in words
Check engine. Amber.
Steady. The engine computer found a fault it cannot fix on its own, and stored a code. The code says where to look. It does not say what to replace. Drive gently. Get it looked at soon. If the car runs normally, drive it gently. Try the free thing first: tighten the fuel cap and give it a few trips.
Flashing. Flashing means the engine is misfiring hard enough that unburnt fuel is reaching the exhaust. That can overheat and ruin the catalytic converter. Stop when it is safe. Ease off the throttle. No towing, no hard driving. Stop when it is safe.
Usually: A loose or worn fuel cap. A tired oxygen sensor, ignition coil or set of spark plugs. An emissions part, such as a vacuum leak or a catalytic converter that has been worn down.
At the car: Yes. He plugs a scanner into your car where it is parked, reads the code, and tells you what it points to. Spark plugs, coils and sensors are routine for him. Internal engine repair is not, and he will say so.
Oil pressure. Red.
Steady. The engine is not getting oil pressure, or the sensor says it is not. Oil pressure is what keeps the moving metal from touching. Stop when it is safe. Pull over and switch off. Wait a minute, then check the dipstick. Do not run the engine to see whether the light goes out.
Usually: Oil level far too low, from a leak or from burning oil. A failed oil pressure sensor or its wiring. A worn oil pump or worn engine bearings. This is the serious one.
At the car: Yes for the common side: oil changes, oil leaks, and topping up so you can see where it goes. A worn oil pump or bearings means internal engine work. He does not do that, and he will say so.
Battery charging. Red.
Steady. The charging system is not putting power back in. The car is running on the battery alone, and that will not last. Stop when it is safe. Switch off the heater, stereo and seat heaters. Drive only as far as somewhere safe. It can stall without much warning, and then it will not restart without a jump.
Usually: A failed alternator. A loose, worn or broken serpentine belt. Corroded or loose battery terminals, or a battery too old to hold a charge.
At the car: Yes. Battery, alternator, starter and serpentine belt are the core of his work, and he tests the whole charging system at your car.
Coolant temperature. Red.
Steady. The engine is overheating. Past this point the damage gets expensive quickly. Stop when it is safe. Pull over now and switch off. Never open the radiator or reservoir cap while it is hot. It can spray scalding coolant. Do not drive it hot to get home.
Usually: Low coolant from a leak. A thermostat stuck shut, or a cooling fan that is not running. A failing water pump, a clogged radiator, or a blown head gasket.
At the car: Yes for the cooling system: leaks, hoses, thermostat, radiator, water pump. A head gasket is internal engine work. He does not do that, and he will say so.
Brake system. Red.
Steady. One of three things: the parking brake is still on, the brake fluid is low, or the car found a fault in the brake system. Stop when it is safe. Check the parking brake first. If it is off and the lamp stays on, do not trust the brakes. If the pedal is soft or sinks, stop when it is safe and call a tow.
Usually: A parking brake not fully released. Low brake fluid, often from badly worn pads or a leak. A leaking brake hose or line, or a failing master cylinder.
At the car: Yes. Brakes are the core of his work and he does them at your car: pads, rotors, calipers, lines and fluid.
ABS. Amber.
Steady. The anti-lock system has switched itself off. Your ordinary brakes still work. In a hard stop on a wet or icy road the wheels can lock. Drive gently. Get it looked at soon. Leave more room and brake early. If the red brake lamp is on as well, treat it as a brake fault and stop when it is safe.
Usually: A dirty or failed wheel speed sensor, or its wiring. A worn wheel bearing or damaged tone ring. A fault in the ABS module, or low brake fluid.
At the car: Yes for the common causes. He scans the ABS module, tests the wheel speed sensors, and replaces sensors and bearings. If the module itself has failed, he will tell you that plainly.
Airbag. Red.
Steady. The airbag system found a fault and may be switched off. In a crash the airbags might not go off. Drive gently. Get it looked at soon. The car drives normally. Do not leave this one. It is a safety system you are counting on.
Usually: A seat belt buckle or seat occupancy sensor fault. A worn clock spring behind the steering wheel. A loose connector under a seat, or a weak battery that set a code.
At the car: He can read the code with a scanner and tell you what it points to. Airbag module repair is not something he does, and he will say so if that is where it ends up.
Tire pressure. Amber.
Steady. One or more tires is well under pressure, or a pressure sensor has a fault. Drive gently. Get it looked at soon. Check all four with a gauge and fill to the number on the door jamb. A tire can look fine and still be low. If one is visibly flat, stop when it is safe.
Flashing. Flashing for about a minute at start-up, then steady, means the pressure system itself has a fault. A dead sensor is the usual reason. Drive gently. Get it looked at soon. Check the pressures by hand. The sensors cannot warn you until it is fixed.
Usually: A slow leak from a nail or a worn valve stem. A cold snap, which drops the pressure in all four. A sensor whose battery has died.
At the car: Not usually. Patching and replacing a tire is a tire shop job. If the pressure keeps dropping and nobody finds a leak, send it to him.
Power steering. Amber.
Steady. Steering assist has been reduced or switched off. The car still steers, but it takes much more effort, most of all at parking speeds. Drive gently. Get it looked at soon. Keep your speed down and plan for heavy steering. If the lamp is red on your car, stop when it is safe.
Usually: Low power steering fluid or a leaking hose, on hydraulic systems. A weak battery or alternator, which starves an electric system. A steering sensor fault, or a failed rack or motor.
At the car: Yes for the battery and charging side, the fluid and the leaks, and for reading the codes. A failed steering rack or motor is a bigger job, and he will say so plainly after scanning it.
Traction and stability control. Amber.
Steady. Steady, this lamp means the traction and stability system has a fault and has switched itself off. The car drives normally without it. Drive gently. Get it looked at soon. Drive as if there is no safety net, especially in rain and snow.
Flashing. Flashing means the system is working right now. It is braking a wheel or cutting power because a tire is slipping. Fine to drive. Slow down. The car is fine. The road is slippery. Ease off and drive smoother.
Usually: A wheel speed sensor or ABS fault. These systems share parts. A steering angle sensor that needs recalibrating after an alignment. A faulty brake light switch or low brake fluid.
At the car: Yes for the common causes. He scans it, tests the sensors, and replaces the parts that failed.
Stability control off. Amber.
Steady. The traction and stability system is switched off, either by the button or by a fault. Fine to drive. Book a check. Press the button once and look. If it stays on after a restart, treat it like the stability lamp and have it scanned. Until then, drive as if it is not there.
Usually: The OFF button was pressed. A sensor fault that shuts the system down. It is shared with ABS. A steering angle sensor that needs recalibrating.
At the car: Yes if it will not clear. He scans it and tests the sensors.
Brake pad wear. Amber.
Steady. The car's sensor says the brake pads are close to the end. Drive gently. Get it looked at soon. The brakes still work. Do not wait. Pads worn to metal chew up the rotors and cost more to fix.
Usually: Pads worn down, which is the usual reason. A wear sensor that has done its job and needs replacing with the pads. A damaged sensor wire or connector, with pads that are still fine.
At the car: Yes. Pads, rotors and wear sensors are the core of his work, done at your car.
Transmission temperature. Red.
Steady. The transmission fluid is running too hot. Heat is what kills an automatic. Stop when it is safe. Stop when it is safe and let it cool. Driving on hot is how a repairable problem turns into a rebuild.
Usually: Low or old transmission fluid. Towing, a heavy load, or long stop-and-go driving in heat. A blocked cooler line, or a transmission that is already worn inside.
At the car: He can scan it and check what sits outside the transmission: the cooling system and the lines. Transmission internals are not work he does, and he will say so if that is where it points.
Glow plug. Amber.
Steady. On a diesel, this coil comes on when you turn the key and goes out once the glow plugs have warmed. That is normal. Fine to drive. Wait for it to go out. Start the engine when it goes out. In the cold it stays on longer.
Flashing. Flashing while you drive, or staying on after the engine is running, means the engine management has found a fault in the diesel system. Drive gently. Get it looked at soon. Drive gently and avoid hard acceleration. Get it scanned soon.
Usually: Normal pre-heat on a cold start. Nothing to fix if it goes out.
At the car: Tell him the engine when you send it and he will say whether he takes it. A scanner read is the first step.
Low fuel. Amber.
Steady. The tank is nearly empty. How much is left varies by car, and you cannot know exactly. Fine to drive. Fill up soon. Do not run it dry. It can strand you, and the fuel pump is cooled by the fuel around it.
Usually: You need fuel. A fuel level sender that reads wrong, if it is on with fuel in the tank. A stuck gauge float.
At the car: Only if it keeps coming on with fuel in the tank. He can scan and test that.
Seat belt. Red.
Steady. Someone is not buckled, or the car thinks so. Fine to drive. Buckle up. If it stays on with everyone buckled, a buckle switch or seat sensor is wrong.
Usually: A belt not clicked in. A heavy bag on a seat, which the sensor reads as a person. A dirty or failed buckle switch.
At the car: Only if it stays on when everyone is buckled. A scan finds the sensor.
Door open. Red.
Steady. A door, the trunk or the hood is not latched, or its switch thinks so. Fine to drive once it is shut. Stop and close it properly. Do not drive with anything unlatched.
Usually: A door not fully closed. The hood or trunk not latched. A dirty or failed latch switch. It can also leave the cabin light on and flatten the battery.
At the car: The switch is a small job. The more common reason to call is a battery that went flat because the light stayed on.
Washer fluid. Amber.
Steady. The windshield washer reservoir is low. Fine to drive. Top it up. Use washer fluid, not water. Water freezes in winter.
Usually: It is simply used up. A leaking hose or reservoir, if it keeps emptying. A stuck level sensor, if it is on with a full reservoir.
At the car: Not his job. A jug of washer fluid does it. Tell him if it keeps emptying itself.
Master warning. Amber.
Steady. The car wants your attention. This is the headline. A message on the display, or another lamp, says what it is. Drive gently. Get it looked at soon. Read the message on the display first. If a red lamp is on with it, treat it as a red.
Usually: A message on the dash: a fluid low, a service reminder, a bulb out. A fault in a system that has its own lamp. Something the car needs scanning to explain.
At the car: Yes. He scans for the stored code behind it and tells you which of those it is.
Key and immobilizer. Red.
Steady. The anti-theft system. A slow blink while the car is locked is normal. A lamp that stays on when you try to start it means the car did not accept the key. Drive gently. Get it looked at soon. If the car is running, it is fine to drive. Do not switch it off somewhere you cannot be stuck. It may not start again.
Usually: A weak battery in the key fob, or in the car. The key not being read. Try the spare. A fault in the immobilizer reader or the key chip.
At the car: Yes for the battery side and for the no-start. He can scan the car to see whether it is the key or the system.
Low beam. Green.
Steady. Your headlights are on, low beam. This is an indicator, not a fault. Fine to drive. Nothing to book. It is telling you the lights are on.
Usually: The headlights are on, as intended. If it stays on with the switch off, a stuck stalk or relay.
At the car: Not usually. If a headlight is out, a bulb is a quick swap. Tell him if the lights keep failing and he will scan the circuit.
High beam. Blue.
Steady. Your high beams are on. Dip them for oncoming traffic and when following another car. Fine to drive. Nothing to book. It is an indicator, not a fault.
Usually: The high beams are switched on. If it stays on after you dip them, a stuck stalk or switch.
At the car: Not usually. Tell him if the beams will not switch off.
This is general guidance, not a diagnosis. If anything feels unsafe, stop and call a tow. Where a light says stop, stop when it is safe.
Tell Fares which light.
Your car and where it is parked. You agree one flat price before any work starts.